
Wireless RGBW 8 Zone LED Remote w/ Cradle for EZ Dimmer Controller

Overview
Designed for use within the EZ Dimmer series, this wireless LED dimmer remote includes a mountable cradle and can be programmed up to 8 zones. The dimmer remote features a color selection wheel that provides thousands of color along with 10 dynamic color-changing modes with dimming and speed control. The dimmer transmits an RF signal to the wireless receiver from up to 65ft away in open air. Requires 3x AAA batteries, not included.



- 1 - 868MHz LED Touch Dimmer Remote
- 1 - Remote Holder
- 2 - Mounting Screws
- DO NOT install with power applied to controller.
- DO NOT expose the Wall Switch or Controller to moisture.
- Follow illustrated steps in the instruction sheet to remove the battery cover on the back of remote. Insert 3 AAA batteries and replace cover.
- Make sure power to the controller is disconnected.
- Using a small flathead screwdriver, loosen the labeled terminal screws visible on the top of the controller.
- Matching light strip wires with labeled slots on the Controller, insert wires and tighten terminal screws. Be sure wire conductor, not wire insulation, is secured in terminal.
- Turn power on and wait until light strip illuminates. If it does not come on, check light strips and wiring connections.
Specifications
Accessories

Reviews
Overall Rating
There are no reviews for this product yet.
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.