
Single Color LED Controller w/ LC2 Connector - Wireless RF Remote w/ Dynamic Modes

Overview
This LED controller with wireless RF remote is perfect for operating your single-color LED light strips. Choose from 8 dynamic light modes with adjustable speed and brightness levels, and control your light strip from up to 50' away in open air. Power-cycle mode retention allows your light strip to return to the mode that was selected before it was powered off. The waterproof remote has a maximum load capacity of 15 amps and is compatible with LED light strips that operate within a 5-24V DC range. A male LC2 locking connector easily plugs into the female connector on your light strip. Pair up to 3 remotes with the controller. Includes remote battery.


Press ‘I’ key to turn on unit or press ‘O’ key to turn off. Retains last setting between power off and power on.
Increases(+) or decreases(-) the brightness level of the light. Initiates Brightness Level Mode if Dynamic Mode is currently active.
Activates the brightness level indicated on the button label. These individual brightness levels are also accessible through the Mode(+)/Mode(-) Bright buttons.
Dynamic modes feature a variety of brightness transitions and patterns, with 8 distinct modes. These buttons initiate Dynamic Mode and cycle through the modes in ascending or descending order.
Increases(+) or decreases(-) the speed of the currently active dynamic mode. Initiates Dynamic Mode if Brightness Level Mode is currently active.
Adjusts brightness in static light mode. Press Flashes blue when remote is operating to indicate that the remote is functioning properly.

The controller/power supply operates at 5-24VDC. The red wire is positive(+) and the black wire is negative(-) as indicated on the controller housing. Make sure the power voltage matches the LED strip requirement. Incorrect voltage may damage the LED strip.
The red cable should be connected to LED positive and black cable to negative. Use LC2 male connector on controller to plug in female LC2 connector on LED strip. The peak output current is 5 amperes.
A multi-color emitting LED located on the remote controller indicates current operating status or operating status changes as follows:


Up to 3 wireless remotes can be assigned to operate the LED controller. Additionally, each individual wireless remote can be assigned to an unlimited number of controllers. The following steps show how to assign a new remote to the LED Controller:
- Disconnect the power to the LED controller, wait 5 seconds, and reconnect.
- Within 5 seconds of reconnecting the LED Controller, press the “50%” and “10%” buttons simultaneously.
- The LED indicator on the LED controller will flash white 3 times indicating the new wireless remote has been successfully assigned. This may be done for a total of 3 wireless remotes.
Up to 3 wireless remotes can be assigned to operate the LED controller. The following steps show how to assign a new remote to the LED Controller:
- Disconnect the power to the LED controller, wait 5 seconds, and reconnect.
- Within 5 seconds of reconnecting the LED Controller, press the “On” and “Bright (+)” buttons simultaneously.
- The LED indicator on the LED controller will flash yellow 3 times indicating the LED controller will recognize any remote.
Specifications
Accessories & Power Supplies

Reviews
Overall Rating
There are no reviews for this product yet.
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.