
Features
- Perfect vehicle area lighting solution for RVs and trailers
- Waterproof aluminum housing and impact-resistant polycarbonate lens
- Surface mounts with included rubber gasket and hardware
- 3 year warranty
- 12-28 VDC
Overview
Add area lighting to RVs, trailers, and UTVs with these LED flood lights. The sealed polycarbonate lens and aluminum housing protect the internal components from extreme weather. Mount the light with the included installation hardware and pigtail connector
- Includes pigtail connector
- Installation hardware included
- Operating temperature: -40 to +122 °F
- 50000 hours L70 lifespan
- Rated IP67 for wet conditions
- 12-28 VDC
- 3 year warranty


- RV and Camper
- Scene Lighting
- Trailer, Towing, and Toy Hauler Lighting
- Interior/Exterior Vehicle Lighting
- Porches
- Utility Vehicles
Specifications
Part NO | Color Temperature | Beam Angle/Pattern | Documentation | Product Weight | Light Distribution | Color Temperature | Product Materials | Color/CCT |
---|---|---|---|---|---|---|---|---|
VAL-CW5 | 5700 | - | - | - | - | Cool 5700K | - | Cool 5700K |
VAL-NW5 | 4000 | - | - | - | - | Natural 4000K | - | Natural 4000K |
VAL-CW5-WH | 5700 | - | - | - | - | Cool 5700K | - | Cool 5700K |
VAL-NW5-WH | 4000 | - | - | - | - | Natural 4000K | - | Natural 4000K |
Accessories

Reviews
Overall Rating
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
Awesome
Installed two of these 13" on the side of my 20 foot enclosed trailer to light up the pit area at the track. I am very impressed. Typical lighting on a race trailer are large recessed halogen lights that need 110 V. These light the whole area like daylight, run off my 12v trailer battery and cost a fraction of the alternative. Cheap, bright light without running the generator. I haven't used them long enough to tell how much battery drain but I would expect it to be minimal being LED.
They are very sturdy construction of cast aluminum not plastic. They also come with perfectly fitting base gaskets. The only thing is they have a cutout on each end to pass the wire through. I drilled a hole and ran the wire through the trailer skin so ended up with an opening on each end. I just put a bit of RTV on to seal up the unused openings.
Impressive light for $15
To be honest, I wasn't expecting this good of a light for $14.95. I am currently building out a high-top Ford Econoline van as a camper and needed a light for under our awning. I was having a hard time finding a good looking "porch" light. Today I mounted this light and I am impressed by both the build quality and light output.