Mini RF Single Color Push Button LED Dimmer Switch w/ Magnetic Base for EZ Dimmer Controller
Overview
Designed for use with the Wireless LED 1-Channel EZ Dimmer Receiver or Wireless LED 4 Channel EZ Dimmer Receiver with Channel Pairing Option, this push-button LED dimmer switch features a magnetic base and provides both standard on/off controls as well as the ability to dim and brighten LED light strips. The push-button dimmer transmits an RF signal to the wireless receiver from up to 300' away in open air. The wireless dimmer includes 2 mounting screws and a required 3V CR2032 battery installed.
- 1 - 868MHz LED Dimmer Push Button Switch
- 1 - 3V CR2025 Battery
- 2 - Mounting Screws
| Single Push | Turns LEDs on/off. If the Controller Pairing Switch has been depressed, a single press on the Push Button Switch pairs the switch to the Controller. |
| Hold Press | Increases or decreases brightness until you release, turning LED on will remember the last memory position |
- DO NOT install with power applied to controller.
- DO NOT expose the Push Button Switch or Controller to moisture.
- Follow illustrated steps to remove the Battery Tray. Insert the 3V battery included with the Push Button Switch.
- Make sure power to the Controller is disconnected.
- Using a small flathead screwdriver, loosen the labeled terminal screws visible on the top of the controller.
- Matching light strip wires with labeled slots on the Controller, insert wires and tighten terminal screws.
- Turn power on and wait until light strip illuminates. If it does not come on, check light strips and wiring connections.
- Press “Pairing Switch” button on the Controller. Immediately press the Push Button Switch to pair it to the Controller. The LED lights wired to the Controller will blink when the pairing is complete.
- Multiple Push Button Switches can be paired to a Controller, and Push Button Switches can be paired to multiple Controllers. If multiple Controllers paired to a Push Button Switch are not in sync, unpair and then pair until Controllers and lights are in sync.
Specifications
Accessories
Reviews
Overall Rating
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
Works perfect with EZD-1C8A
I bought this to turn on some strip lights that I installed on a desk project for my home office. The strip lights are single color so this button (and the wireless controller) are the perfect solution. The pairing was simple and quick and it works the first time, every time. I will definitely buy again if I need a similar solution.
