
Save 10% On Your Entire Order using code MEMDAY22
Overview
Designed for use with the Wireless LED 4-Channel EZ Dimmer Receiver, this wireless LED dimmer switch fits in standard wall switch boxes and provides on/off control as well as fixed levels of dimmability. Double-clicking the knob switches between dimmer and RGB control. The dimmer knob transmits an RF signal to the wireless receiver from up to 300' away in open air. The wireless dimmer includes 2 mounting screws and a required 3V CR2032 battery installed.



- 1 - 868MHz LED Dimmer Wall Switch
- 1 - 3V CR2032 Battery with Tray
- 2 - Mounting Screws
Single Press | Turns light on/off. If the receiver learning key has been depressed, a single dial press on the wall panel switch links the switch to the receiver. |
Double Press | Increases or decreases brightness until you release, turning LED on will remember the last memory position. |
Left/Right Movement | During color mode, scrolls through RGB light strip colors. During dimming mode, controls LED brightness level. |
Hold Press | Increases light to max brightness. |
Set-Up and Operating Instructions
- Follow illustrated steps below to remove the front face plate. Insert the 3V battery included with the wall switch.
- Make sure power to the controller is disconnected.
- Using a small flathead screwdriver, loosen the labeled clamp screws visible on the top of the controller.
- Matching light strip wires with labeled slots on the controller, insert wires and tighten clamp screws.
- Turn power on and wait until light strip illuminates. If no illumination occurs, check light strips and wiring connections.
- Pull off dial and collar from front plate.
- Using a flat head screwdriver, pry rear switch housing away from front plate.
- Insert battery with tray into slot, matching the polarity on the battery with the slot labels.
- Fasten wall switch using mounting bolts.
- DO NOT install with power applied to controller.
- DO NOT expose the Wall Switch or Controller to moisture.
- Press "Learning Key" button on the receiver. Immediately press the dial on the wall switch to link it to the receiver. The LED lights wired to the receiver will blink when the linking is complete.
- Multiple wall switches can be linked to a receiver and wall switches can be linked to multiple receivers. If multiple receivers linked to a wall switch are not in sync, unlink and then relink until receivers and lights are in sync.

Specifications
Accessories

Reviews
Overall Rating
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
Works great! Attractive light control
This is only item 1 of the two but as long as these products are used as a pair they work amazingly. Easy to use, Easy to function easy to hook up. I used this on a set of inexpensive 5050 SMD RGB LED strip lights and it works exactly as it should. The only issue I ran into was actually trying to get the wireless control knob to pair to the controller. After turning the power off completely two or three times and attempting to pair them 2 or 3 times. It finally paired and the two work flawlessly together. Even when I couldn't get it to pair by myself. I called into tech support and they helped me walk through to initialize the pairing/synchronizing process. Thanks again super bright LED's