Overview
Bare Circuit Board. Add LEDs to create your own custom colors. Has pads for Four 5mm LEDs and One 1/4 Watt resistor. Mesures 1-3/4 x 3/8 inch, fits standard 194 size wedge base socket.
Specifications
Reviews
Overall Rating
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
-
NameCameron
-
Technical LevelAdvanced
-
Part NumberMLED-PCB
-
Reviewed On01/26/16
A Good Start
I bought one of these to custom make a glovebox lamp, using three cool white LEDs and one blue LED with matching resistor.
To get the board to fit properly, I did have to flow solder over the bottom contacts, file, and reflow to fit correctly, but I won't subtract any points for that.
The board itself is well made, and was very sturdy.
However, my biggest gripe with the board is there's no diagram of any sort to tell you where to place what in a case where it's meant to be a static configuration. Although it's easy enough to figure it out while in hand, some kind of key or legend to the board would be great. Another thing that ought to be tweaked is the overall width of the board where the LEDs sit. If you place them all on one side as I did, they don't really fit all that great, but still doable. Another gripe is the placement of the resistor, as it somewhat interferes with one of the LEDs. Looking past all that, it's still a perfectly fine board to use in a small project.
