Car Light Bulbs
LED Strip Lights & LED Bars
LED Home Lighting
LED Landscape Lighting
Off Road LED Light Bars
LED Auxiliary Work Lights
Commercial Truck LED Lights
Emergency Vehicle & Strobe Lights
LED Accent Lighting
Motorcycle LED Lights
RV LED Lights
Boat LED Lights
LED Flashlights & Flashlight Bulbs
Off-Grid LED Lighting
Industrial LED Lighting
Commercial LED Lighting
Hotel & Casino Lighting
12V DC CPS series Power Supply
- Select options to see various notes.
|50 - 99 pieces||$8.89 to $13.39 each|
|100 - 499 pieces||$7.90 to $11.90 each|
|500 - 999 pieces||$7.41 to $11.16 each|
|1000 + pieces||$6.92 to $10.42 each|
|For discount information or inquiring about larger quantity pricing, click here|
- Non-Weatherproof, Indoor use only unless contained within weatherproof housing or used in conjunction with weatherproofing products
CPS-12VDC-xW series compact power supplies. 100~240V AC input, 12V DC output. Includes AC in and DC out cables with a 5.5mm barrel connector. See our Power Supply Selection Guide.
|Connection Type||CPS Male||DC Jack Type||5.5 Barrel Connector|
|Input Frequency Range||50 ~ 60 Hz||Input Voltage||100 ~ 240 VAC|
|Output Voltage DC||12 VDC||Power Supply Type||Compact|
|Special Features||With AC Input Plug||Standards And Certifications||UL Listed|
|Type||Power Supplies||Volts||12 VDC|
Package Dimensions: 3.31" (8cm) x 2.28" (6cm) x 2.28" (6cm)
Package Weight: 2.87oz (0.08kg)
|Connection Type||CPS Male|
|DC Jack Type||5.5 Barrel Connector|
|Input Frequency Range||50 ~ 60 Hz|
|Input Voltage||100 ~ 240 VAC|
|Output Voltage DC||12 VDC|
|Power Supply Type||Compact|
|Special Features||With AC Input Plug|
|Standards And Certifications||UL Listed|
Dimensions: 3.31" (8cm) x 2.28" (6cm) x 2.28" (6cm)
|Image||Part NO||Beam Angle |
Beam angle is used to express the width of the light emitting from the source. The narrower the beam angle the more focused the light energy is. Comparing two 40 watt lights one with a beam angle of 30(a) and another with a beam angle of 90(b), They both produce the same amount of light output but (a) will appear brighter in the beam angle compared to (b) at the sacrifice of light spread.
|CCT / Wavelength |
CCT is used to express the color or shade of white light. The Correlated Color Temperature is the measure of the color appearance of the light emitted from a light source, measured in degrees kelvin (K). The CCT rating is a general 'warmth' or 'coolness' measure of its appearance. Wavelength is used to express a specific color of light other than whites. Wavelength is the portion of the visible spectrum that the human eye can detect, between 380 and 700 nanometers (nm). When trying to match an existing bulb color choose a replacement that most closely matches the CCT or wavelength of the original.
|Part Number||Output Power||Dimensions (in.)||Wire Length (in.)|
|CPS-12VDC-6W||6W (500mA)||2.5 x 1.5 x 1||58|
|CPS-12VDC-15W||15W (1250mA)||2.625 x 1.75 x 1||58|
|CPS-12VDC-24W||24W (2000mA)||2.75 x 2.25 x 1.25||68|
|CPS-12VDC-50W||50W (4170mA)||4.75 x 2.125 x 1.25||58 and 57|
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
Delay when turning on
Bought a pair of the 50W models for powering NFLS-X3 strips, 2 meters on one and 3 meters on the other one so I'm not trying to draw too much power from them, both of them however have about a 2-3 second delay from when power is connected to when the light strips turn on which is frustrating for room lighting and ultimately I will replace them with something else for that reason.
They otherwise work great, It's just the delay with turning on that I don't like.
The CPS-12VDC-50W is designed to have a short (about 1second) delay at start up to allow the voltage and current to stabilize prior to being applied to the load. While it isn't really needed for the strips there are applications where it can be used where it is necessary.
Use it to drive the Dream Chaser strip and the little controller. 240 high intensity RGB LEDs along with the controller and it didn't miss a beat. It did get a tiny bit warm but for a wall wart that's to be expected. Just make sure where ever you plug it in there's some air flow around it.
Great products, impressive service, SuperBrightLeds.com.
Reliable Power Supply
I am using this PS for three rigid LED strips in a Christmas Display. I have experienced no problems, and I would recommend that you buy a higher rated PS than you need. Cutting it too close could work your PS too hard, and the prices are great here, so buy a little more than you need. I usually double what i need, but you should at least buy 1/4 more watts than you need.
I used this product in conjunction with NFLS-NW30X3-WHT strip. The strip was cut in half and a Y-Connector powered both from the DC power source. The lighting was on all the time for 21 months. The LED strips still operate but the DC adapter failed. Being the the adapter is almost as expensive as the lights, it makes little sense to go this route if the adapter fails in so short of a time, in comparison to the lights. The adapter seems to be the weak link in a system that was desired to last longer than a small florescent tube light it replaced.The adapter is more than adequate to handle the power.
Super Bright products always work perfectly.
I wish you could see just how great the LED lights are to enhance our deck. No more fooling around pulling any plugs from either summer or winter lighting when using Super Bright and SmartHome products. They make every use simple to use and enjoy.
Just connect them together and watch the magic.
12 V DC Power Supply
As always on time delivery and accuracy. Easy to use and to install. Works well and will be bought and used again by myself in the near future. I don't know how to rate this product and company higher than 5 stars and Excellency!!!
This is being used to power some 12V LED bulbs in a project. It works great for that. I like that the AC prongs re situated so that the power supply takes up only one outlet space on a dual outlet.
Working well so far
Plugged and played. I was confounded by the power-on delay when I first turned on the master on our panel, but after I was educated, I was happy with the power supply.
I have no idea of time-before-failure, but with good ventilation, this supply should last a considerable amount of time.
Report Review as Inappropriate
Customers Also Purchased
Outdoor LED Light Strips - Weatherproof LED Tape Light with 18 SMDs/ft. - 1 Chip SMD LED 3528
Starting at $7.88
Waterproof LED Light Strips with Multicolor LEDs - Outdoor LED Tape Light with 18 SMDs/ft. - 3 Chip RGB SMD LED 5050
Starting at $39.95
LED Light Strip - High CRI - 16.4ft (5m) Super Slim High Density LED Tape Light with 27 SMDs/ft. - 1 Chip SMD LED 3528 with LC2 Connector
Starting at $59.95
Outdoor LED Light Strips with RGB LEDs - Weatherproof LED Tape Light with 18 SMDs/ft - 3 Chip RGB SMD LED 5050
Starting at $119.88
LED Strip Lights - LED Tape Light with 18 SMDs/ft. and LC2 Connector - 3 Chip SMD LED 5050
Starting at $11.95
Round LED Truck and Trailer Lights w/ Grommet - 3/4” PC Rated LED Side Clearance Light w/ 3 High Flux LEDs - Pigtail Connector
Starting at $5.95
Smartphone or Tablet WiFi Compatible RGB Controller w/ RF Touch Color Remote - Dynamic Color-Changing Modes
Starting at $44.95
LED Light Strips - LED Tape Light with 36 SMDs/ft., 1 Chip SMD LED 3528 with LC2 Connector
Starting at $89.95
LED Light Strips - Copper Finish LED Tape Light with 18 SMDs/ft., 3 Chip SMD LED 5050
Starting at $7.88