
Solderless Clamp On LED Strip Light to Pigtail Adapter - 8mm Single Color Strips - 22-18 AWG

Overview
Use this solderless adapter to connect your 8-mm single-color LED strip light to 22-18 gauge pigtail power wire. The clear connector easily clamps onto strip ends and pigtail wire without stripping insulation. A secure-snap closure holds wire and strip in place.

Specifications
Reviews
Overall Rating
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
They work, but have flaws.
These function ok, but only if you buy the correct wire type. The wire piercing end doesn't work on durable insulation types, and if you use 18AWG wires, they might actually be to big to fit.
Once you get them snapped into place, they work just fine. But it could be a bit of a struggle until you get used to it. I would suggest buying a few more than you think you'll need as you'll probably mess up a few before you find your groove.
Once you get into a flow and have the correct wire, they are good.
Cheap, Not worth buying
This barely works for the 22 gage, does not close or make contact with the metal that well. Does not work at all with the 18 gage. Wire definitely will not close at all, nor go into the metal splice groves inside, even if you trim to bare wire. Cheap little plastic nubs on side to grip the top will not hold and strips smooth while trying to make it close. IF you decide to buy anyway, make sure you have a piece of your light strip connected with the power going thru to make sure you connection is good, while installing, if not, you will find your connection came loose inside that clamp. I had to hot glue it closed with pliers holding it shut. Don't waste your money on this item.
need to list the diminsions on web site.... i really wanted it to fit inside the track
will have to find larger track next time to fully enclose solderless clamp..
Response from Super Bright LEDs:
Solderless Clamp on Strip Light Connector
These things are somewhat fickle to use on 18 gage wire. You really only have one shot to use on 18 Gage wire otherwise if it closes a bit off. it becomes useless and a throw away. It is not consistent. Bit of a pain in the ass. Needs improvement!