Solderless Clamp On LED Strip Light to Pigtail Adapter - 10mm RGB Strips - 22-18 AWG
Overview
Use this solderless adapter to connect your 10-mm RGB LED strip light to 22-18 gauge pigtail power wire. The clear connector easily clamps onto strip ends and pigtail wire without stripping insulation. A secure-snap closure holds wire and strip in place.
Specifications
Reviews
Overall Rating
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
-
NameAnonymous
-
Technical LevelAverage
-
Part NumberSTN10-4PC
-
Reviewed On01/17/19
Does any of your stuff come with instructions?
It says "clear connector easily clamps onto strip ends and pigtail wire without stripping" but i still cant get these to work. Sheeze.
Staff
Response
To successfully use these connectors, you must take care to cut the strip at the indicated cut point and make sure that the strip is inserted fully in the strip side of the clamp. The wire you are using must also be inserted fully to insure best contact. It has been reported that removing the double stick tape from the back of the strip where you are making a connection, will make the connection easier.
-
NameLeo
-
Technical LevelAverage
-
Part NumberSTN10-4PC
-
Reviewed On12/25/18
Awesome, but no instructions
It took a bit to figure out how to make this product work as it came with no instructions. Once I got figured out, they work GREAT. The key to making this work is to REMOVE the adhesive cover from the back of the LED strips prior to applying the connecting clamp. Additionally, be sure to put led strip on the correct end of the connector. The connectors are not marked, so put the LED strip into the shallow side of the connector and the wire in the deep side.
