NFLS-2CS90 2 Contact 8mm Flexible Light Strip 90 Degree Connect
Overview
NFLS-2CS90 flexible light strip 90 degree connector. 8mm wide solder-less, inserts connects two single color NFLS series flexible light strips.
Reviews
Overall Rating
Total Reviews
Tell Us What You Think
Share your own experience and photos of this product. Doing so will help inform other potential buyers and allow us improve our product lines. It may take up to 72 hours for your review to appear.
-
NameAnonymous
-
Technical LevelAverage
-
Part NumberNFLS-2CS90
-
Reviewed On02/19/18
No clue how to use these
I was happy when I found these as it seemed like a perfect solution for my application but they just come in a sealed bag with no directions what so ever. I was hoping to find a video here with even basic instructions but no luck. The difference between a 1 and 5 star review is instructions.
Staff
Response
To use these connectors, gently pull the black bar out until it stops. Insert the LED strip and then push the black bar back into position to activate the clamps.
-
NameAnonymous
-
Technical LevelAdvanced
-
Part NumberNFLS-2CS90
-
Reviewed On05/12/18
A bit awkward
- works, simple
- poorly constructed (see below)
- no instructions
Easy method:
- Critical: carefully scrape/remove tack/glue from back of LED strip where the copper tabs will insert in (copper tabs to pin side). Recommend a little scraping of solder from front side - start slow/small and try as you go.
- Do not pull too hard on black tab/clamp, as you can separate the connector from the main board, was able to align and re-seat connector, still works - just frustrating.
- power LED strip, connect corner assembly, connect next LED strip. May need to re-adjust one (or both) connections until second LED strip powers up.
Appears expectation is that you are already familiar with how to use these. Done correctly, these make for a nice horizontal corner. Alternatively, solder and go. Just be mindful of "+" and "-".
What would be nice would be the 2 contact connector (NFLSn/nn-2CSH) in a *very* short configuration to turn corners horizontal/vertical in same space as LED strip width.
-
NameCurtis
-
Technical LevelAdvanced
-
Part NumberNFLS-2CS90
-
Reviewed On03/09/17
Not so good
I found these difficult to use. They don't come with instructions and I could not find a way to connect them that was reliable. I gave up and just soldered the connections instead. Fortunately that was very easy and 100% effective.
Staff
Response
Some reduction of the solder on the connections points may be required to enable the connector to work as designed.
