LDRF-RGB6-TC2 RGB Controller w/ Sync-able RF Touch Color Remote
- Do not use amplifier until max run of RGB Controller or RGB Amplifier is met.
|Universal Red/Green/Blue (RGB) LED Controller & Dimmer with handheld RF Touch Color Remote can control any 12VDC RGB LED products. Unique synchronization function constricts remote to one controller, or to multiple controllers for use with one remote. Select from several static single color modes or 15 dynamic color-changing modes with speed, dimming, ON/OFF controls. Maximum load is 6 amps per channel, 18 amps total.|
|Standards and Certifications|
LDRF-RGB6-TC2 RGB Controller with Sync-able RF Touch Color RemoteINSTRUCTIONS & SPECIFICATIONS
LDRF-RGB6-TC2: 12VDC RGB LED Controller
|Applications:||Direct access color selection and functions with dimmable and speed controls|
|Function:||Control 3 channel RGB LED products using wireless RF remote|
|Operating Voltage:||12 VDC – match power supply voltage to RGB LED product voltage|
|Connection Mode:||Common Anode (+)|
|Output:||Three CMOS drain-open output|
|Maximum Load Current:||12VDC – 6 Amps per channel (18 Amps total)
24VDC - 6 Amps per channel (18 Amps total)
|Output Power:||216 Watts|
|Control Method:||Wireless RF Remote Control - Frequency 433MHz|
|Batteries Required:||Three AAA batteries|
|Modes:||39 Total (24 static single color and 15 dynamic color changing)|
The LDRF-RGB6-TC2 features transmitter to receiver keying to help eliminate interference from other nearby units. If you wish to control several receivers from a single transmitter, the receivers first must be re-programmed. The easiest and fastest way to re-program several receivers at once is to have them share a power supply or all plug in to a single power strip (Once programmed you can provide power as you would otherwise, sharing is only needed for the programming phase to ease the process -- Re-programming can be done one device at a time also).
- Wire all receivers to one power supply or power strip but don't turn it on yet.
- With the power off, grab the remote.
- Turn on the power supply.
- Within 3 seconds of providing power press the button once.
If programming was successful any connected light strings should blink three times.
1.) Do not scratch the sensing area. Do not disassemble, repair, or modify the device.
2.) Disconnect the power (adapter) before installing/removing this controller.
3.) Do not use this device near water, or moisture for indoor use only.
4.) This product should only be operated from the type of power source indicated on the label.
5.) When mutliple receivers share one remote, it's possible for the patterns to visually drift apart over time. The single color modes are unaffected and remain synced.
RF Touch Color Remote Control
Typical Wiring Schematic
|RGB Light Bars & Strips||Universal RGB Controllers and Dimmers|
Numbers below represent the maximum number of units the controller can drive without the use of RGB amplifiers
Numbers below represent the maximum number of units the Amplifier can drive
|Product||Current Draw @ 12 Volt DC||Product Length||Max Run*||LDRF-RGB6-TC2||RGB-A4||RGB-WA4||MRGB-A4||MRGB-A4-CPS||RGBW-A6|
|* Maximum number of light bars in one run (end to end) - for higher quantities, multiple runs back to the power supply, controller, or amplifier must be made to prevent excessive voltage drop Note: To determine the maximum number of any LED products on a single Power Supply - divide the total current capability of the power supply by the current draw of the LED product - then multiply that number by 0.8 (for 80% capacity)|