Power wire, connectors, fuses/fuse holders, etc. for wiring installation of LED products
Two Conductor Power Wire, Black Nylon Cable Ties, Double-Sided Foam Tape, Splice Taps, Butt Connectors, Toggle Switch, Female Push-Ons, Mini-Automotive Blade Fuses, Circuit Protection Fuse Tap, Easy-Crimp Fuse Holder, and Waterproof Fuse Holder.
Two Conductor Power Wire
Power Wire for low voltage installations
18 Gauge Two Conductor Parallel Bonded Wire
14 Gauge Two Conductor jacketed Brake Cable resistant to standard automotive oils, grease and chemicals 24 Gauge Two Conductor Parallel Bonded Wire
Heat Shrink Tubing: Dual Wall Heat Shrink Tubing for weatherproofing exposed wire connections
Corrugated Split Loom: Black Polyethylene Corrugated Split Loom
Snap Bushing: Eliminates sharp edges and protects wires and harnesses passing through holes in metal plates and panels.
Splice Taps: Insulated Displacement Connector Terminal Splice Tap for 18 to 14 Gauge wire - 3M Waterproof Sealant Filled
Butt Connectors & Wire Nuts: Moisture Resistant Butt Connectors & Wire Nuts for secure wire connections
Push On Female Connectors: Nylon, 1/4", fully insulated, accept 22-18 and 16-14 Gauge wire
ON/OFF Toggle and LED Indicator Rocker Switches
TBS-SP Toggle Switch: 15 Amp 12VDC ON/OFF SPST Black Nylon Toggle Switch with two 1/4" Male Contact Terminals - Mounting stem is 15/32" diameter and fits panels up to 1/8" thick
RRS-SP LED Indicator Rocker Switch: 15 Amp 12VDC ON/OFF LED Indicator Rocker Switch with two 3/16" Male Contact Terminals - fits panels up to 1/8" thick
WRRS-SP Weatherproof Toggle Switch: 20 Amp 12VDC ON/OFF IP65 Weatherproof SPST Black Nylon Toggle Switch - Standard or Red LED indicator switches - fits panels up to 1/8" thick
Mini-Automotive Fuse Supplies
Mini-Automotive Blade Fuses, Circuit Protection Fuse Tap, Easy-Crimp Fuse Holder, and Waterproof Fuse Holder for automotive aftermarket lighting applications
UV resistant Black Nylon Cable Ties: 4 inch Cable tie - .875" max dia.; 11 inch Cable tie with - 3.062" max dia.; 16 inch Stud Mount Cable tie - 4.125" max dia.
Heavy Duty Mount for Cable Ties:Use for securing wires to surface. Small tab contained inside the mounting hole temporarily engages threads, allowing assemblers to pre-install the mount on a stud before securing with a washer and nut (not included)
Nylon Push Mount Base for Cable Ties:Cable tie mounting base to secure wires on surface. Fits 1/4" diameter hole - For ties up to 3/8" wide
Closed-Cell Acrylic Foam Tape Strips and Pads: high performance Foam Tape Strips or Pads - adhesive on both sides for attaching Light Bars and other LED products to a wide variety of surfaces
LED Rocker Switch
WRRS series Weatherproof Toggle Switches