MR16 and MR11 LED Bulbs
|
||||||||
MR16-W5 White 5 Watt LED bulbGX5.3 base MR16 bulb with one 5 Watt Seoul P4 LED 
|
||||||||
 close(x)Important Note : LED bulbs are compatible with all types of magnetic transformers but if they exceed the maximum voltage rating for the LED bulb, the LEDs will fail prematurely. Many electronic transformers require a minimum load which is greater than that provided by LED bulbs. LED bulbs will usually not work properly (no light output, flickering, strobing) in fixtures that have integral electronic transformers in each fixture. We recommend changing the power supply to a 12 VDC regulated type if possible. Otherwise you must make sure that the voltage of your existing power supply does not exceed 14 Volts with the LED bulbs installed. Many standard Track Light power supplies will produce voltages as high as 16 with little or no load (LED bulbs provide little load). If you run a couple of standard bulbs with the LED bulbs this will usually load the power supply down to a safe voltage but it is always best to actually measure the voltage to make sure. |
||||||||
MR16-W4 White 4 Watt LED bulbGX5.3 base MR16 bulb with Three 1.3 Watt Nichia LEDs 
MR16 Bulbs with High Power 1 Watt & 3 Watt LEDsMR16 type GX5.3 base bulbs with High Power 1 or 3 Watt LEDs 
MR16 Bulb with
|
||||||||
 close(x)Important Note : Only use dimmers intended for use with low voltage transformers. Common 120 Volt wall switch type dimmers will not work with low voltage systems. Dimmer manufacturers normally offer dimmers designed to work with electronic or magnetic transformers. |
||||||||
MR11 Bulbs with 3mm & High Power SMD LEDsMR11 type GZ4 base bulbs with 3mm or High Power SMD LEDs 
G4 Lamps with High Power SMD LEDsGZ4 base bulbs with High Power Cool White or Warm White LEDs
Built-in Buck Driver allows wide operating voltage range of 8~30VDC (8~14VAC) 
GU10 Base MR16 Bulbs with High Power 1 Watt LEDsHigh Power MR16 GU10 Bi-pin Twist-Lock base LED bulbs 
| ||||||||
 close(x)Important Note : Excessive heat will cause LEDs to fail prematurely. They must be operated in an ambient temperature, not exceeding room temperature, for maximum life time. As the temperature rises above 23 degrees C, the life time goes down. Active cooling, such as a small fan, may be required if they are installed in a small enclosed space without ventilation. We do not make claims that these bulbs are drop-in replacements for all light fixtures with similar bulbs. We always recommend powering them only with a 12 Volt DC regulated power supply. Unregulated AC power supplies will often exceed the maximum voltage of these bulbs and cause premature failure which is not covered by our warranty. MR16 and MR11 SocketsCeramic 2-Pin base GX5.3/GU5.3 or GZ4 fits all MR16 and MR11 bulbs 
12 Volt DC Power SuppliesCompact, enclosed and waterproof 12VDC power supplies Ranging from 15 Watts to 100 Watts, with 120~240VAC inputs 
|
||||||||
Here are some other pages you may be interested in |
||||||||
